|
The ZG400 B2 is specially designed for wire, cable and ropes wire. It is capable of the material by means of two counter-running coils of feed belts or drums to be deducted. The maximum coil weight must not exceed 300kg. The coils must be positioned with ball bearings on a stub shaft or a similar smooth roll-off. It is powered by a powerful servo motor. The maximum speed is 1.35m/sec. All controls are easily accessible placed on the device. The speedregulation by means of the dancer arm is moved by the material or, alternatively, with the sag control DHS1000D. The material support length is 400mm. Dimensions: approx. 650 x 400 x 460mm
Compressed air supply: max 6 bar / 87psi
Electricity: 230V/50-60Hz/16A Optionally, the device can be provided with a basic stand |
|
|
NEW! The rotary cutting machine SMM40 |
|
 This innovative rotary cutting machine has been developed in particular for cutting material (i.e. tubes, canals, hoses) in high quantities. The SMM40 offers two options to cut the material. Depending on your requirement, the machine can universally operate in either "static blade mode" or "rotary blade mode". A short video is available on the product page. Go to product! |
|
|
NEW! The Heat-shrinkable tube cutting machine SSM800 |
|
 Designed on customer requirement. The SSM800.
To cut heat-shrinkable tubes up to 500 mm of diameters. With pre-connected sag control DHS1000D/800, covered for the extruder operation with up to 25 m per minute fast! A short video is available on the product page!
go to product! |
|
|
